Gate Remote Control - Fixed Code 433MHz

Description

Product Details: - Fixed-code gate remote control operating at 433MHz - Channels: 4 - Frequency: 433MHz - Rated voltage: 12V - Rated current: 10mA - New Delivery Details: - Hand delivery (São Domingos de Rana, Algés, Amoreiras or Cais do Sodré) - Standard mail (€2.00) - Registered mail (€3.00) - Cash-on-delivery mail (€6.00, paid in advance via bank transfer or other equivalent method) Payment Methods: - Bank transfer - MB Way - Cash - PayPal (+€3.00) Remote Control Operation Instructions: 1. Clearing the code: Simultaneously press and hold both the unlock and lock buttons with two fingers; the LED blinks rapidly three times within approximately 2 seconds; release one finger (do not release the other hand’s finger), then use the released finger to quickly press the released button three times until the LED blinks rapidly; both fingers may now be released; next, press any key on the remote; when the LED turns off, it indicates successful code clearance (all four keys are now empty); if, after pressing any remote button, the LED remains lit, this indicates that the original code was not successfully cleared. You must repeat the clearing procedure, and only after successful clearance can cloning proceed. You may repeatedly clear and clone the code. 2. Copying: Hold the original remote in your left hand and our cloned remote in your right hand, keeping both remotes as close together as possible; simultaneously press the first buttons of both remotes; within approximately 2 seconds, the LED blinks rapidly twice; after one second, the indicator light continues blinking, then release your fingers; next, press the corresponding key after successful learning—the LED stays lit continuously, indicating that the first key’s code from the original remote has been copied to the cloned remote; the same method applies for binding the second key, third key, etc. If copying succeeds, the cloned remote’s functionality matches that of the corresponding original remote. 3. Restoring: If you accidentally clear the cloned remote’s code, simultaneously press the two lower keys of the cloned remote—the LEDs blink rapidly; after releasing any key, the LED stays lit for an extended period, indicating that the remote’s code has been restored. Before using our cloned remote, ensure you have cleared any existing code from it. How to handle situations where some keys function but others do not: Perform the clear-and-restore operation. Specific steps are as follows: 1. Clear the code; 2. After clearing, re-copy only the key(s) that failed previously—no need to re-copy the remaining buttons; 3. Clear the code again; 4. Restore the code; at this point, originally unsuccessful keys are now overwritten with new codes, while originally successful keys remain retained. If no copy occurs after the second attempt, repeat the above steps until all keys are successfully copied. Features: Superior range, enhanced durability, and long-lasting battery. Includes transmission LED and low-battery indicator for visual status and operational mode feedback. Includes a belt clip for convenient carrying. Applications: Vehicle central locking systems, garage doors, electronic doors, automobile sunroofs, heating systems, etc. Remote control only—other accessories shown in images are not included! Suggestions: 1. Selecting the prerequisite remote: The original remote must function normally; its chip must be identical or compatible; its operating frequency must match. 2. This remote can only copy fixed codes, learn chip codes, and partially copy single-chip remotes (check supported chip models for compatibility). 3. Two-way remotes, rolling-code remotes, and integrated-circuit encryption-programmed remotes cannot be copied—e.g., HCS200, HCS201, HCS300, HCS301, etc. 4. Before copying, ensure the existing code in the remote has been cleared and verify successful clearance; otherwise, copying will fail. 5. Ensure your remote has sufficient power; greater distance between the two remotes yields better results. 6. If copying distance is too close, try different angles relative to the switch. Press and hold the original remote’s button to fully transmit the signal normally, then press the cloned remote’s button to ensure complete functional replication.