Gate Remote Control - Fixed Code 433MHz

Description

Product Details: - Fixed-code gate remote control, 433MHz - Channel: 4 - Frequency: 433MHz - Rated voltage: 12V - Rated current: 10mA - New Delivery Details: - Hand delivery (São Domingos de Rana, Algés, Amoreiras or Cais do Sodré) - Standard mail (€2.00) - Registered mail (€3.00) - Cash-on-delivery mail (€6.00, prepaid via bank transfer or other equivalent method) Payment Methods: - Bank transfer - MB Way - Cash - PayPal (+€3.00) Remote Control Operation Instructions: 1. Erasing the code: Press and hold the unlock key and the lock key simultaneously with two fingers; the LED flashes rapidly three times within approximately 2 seconds; release one finger (do not release the other finger); then use the released finger to quickly press the released button three times until the LED flashes rapidly; both fingers may now be released; next, press any key on the remote control; when the LED turns off, it indicates successful code erasure (all four keys are now empty); if, after pressing any button on the remote control, the LED remains lit, this indicates the original code was not erased successfully. You must repeat the code erasure process; only after successful erasure can cloning proceed. You may repeatedly erase and clone the code. 2. Copying: Hold the original remote control in your left hand and our cloned remote control in your right hand, keeping both remotes as close together as possible; simultaneously press the first keys of both remote controls; within approximately 2 seconds, the LED flashes rapidly twice; after one second, the indicator light continues flashing—then release your fingers; next, press the key after a successful learning session—the light stays on, indicating that the code from the first key of the original remote has been copied to the other remote; the same method may be used to copy the second key, third key, etc. If copying is successful, the function of the remote matches that of the corresponding original remote. 3. Restoring: If you accidentally erase the copied remote control code, simultaneously press the two lower keys of the cloned remote control—the LEDs flash rapidly; then release any key, after which the LED stays lit for an extended period, indicating the remote control code has been restored. Before using our cloned remote control, ensure you have erased any existing code from the remote. How to handle situations where some keys operate correctly but others do not: Perform the erase-and-restore operation. Specific steps are as follows: 1. Erase the code; 2. After erasing the code, re-copy only the key that failed previously—there is no need to re-copy the remaining buttons; 3. Erase the code again; 4. Restore the code; at this point, originally unsuccessful keys are now overwritten with new codes, while originally successful keys are retained. If no successful copy occurs after the second attempt, repeat the above steps until all keys are successfully copied. Features: Better range, greater durability, and longer battery life. Includes transmission LED and low-battery indicator for visual status and operational mode indication. Includes a clip for convenient carrying. Applications: Vehicle central locking systems, garage doors, electronic doors, automobile sunroofs, heating systems, etc. Remote control only—other accessories shown in images are not included! Suggestions: 1. Selecting the prerequisite remote control: The original remote control functions normally; its chip is identical or compatible; its operating frequency matches. 2. The remote control can only copy fixed codes, learn chip codes, and partially copy single-chip remotes (check chip type compatibility for copiable models). 3. Two-way remotes, rolling-code remotes, and integrated-circuit encryption-programmed remotes cannot be copied—e.g., HCS200, HCS201, HCS300, HCS301, etc. 4. Before copying the remote control, ensure any existing code has been erased and verify successful erasure; otherwise, copying will fail. 5. Ensure your remote control has sufficient power; greater distance between the two remotes yields better results. 6. If the copying distance is too close, try copying at different angles relative to the switch. Press and hold the button on the original remote control to fully transmit the signal normally, then press the button on the cloned remote control to ensure complete functional replication.